Domestic rabbits are highly valued for their low fat, low cholesterol and high quality protein. Rabbit meat compares very favorably to chicken, turkey and some fish for its beneficial health virtues and its palatability.
Steps
Raising Rabbits
- Rabbit breeding stock can be obtained from many different sources. One good way is to go to a fair where there are rabbits and contact the owners which are usually listed on the show cases.
- 3 to 4 litters of 5 to 10 young can be thrown by a healthy, mature female (doe) each year.
- One male (buck) can service up to twenty to thirty does, but in order to keep the gene pool healthy, you should have one buck for each 5 does. Make sure you keep records of which does are bred by which bucks, and keep rotating the animals to keep the gene pool as large as possible.
- One good breed is the Flemish Giant. The young from this breed will be ready to butcher at 3 months, yielding a very tender meat. Most consider the Flemish Giant unsuitable for a meat rabbit, due to the meat to bone ratio, also the amount of food consumed to meat ratio. It is okay to cross with a New Zealand for meat production.
- 3 to 4 litters of 5 to 10 young can be thrown by a healthy, mature female (doe) each year.
- Get the right pen. The pen should be 3 feet by 3 feet for this large breed, but somewhat smaller for the smaller breeds. The floor should be made of a sturdy wire mesh with about 3/4 inch square holes to accommodate droppings and urine. Do give the rabbit someplace else to stand, however. Standing on wire full time can hurt a rabbit's feet. A full tray or box the full size of the floor of the pen with all four sides about 2 1/2 inches high should be slid under the pen to catch the animal waste. This tray should be emptied once per week and rinsed with a disinfectant. Be careful when using bleach, as it will react with the urine and give off a harmful gas!
- A solid compartment about 1 1/2 feet long and 1 1/2 feet wide should be included in the pen to give the doe privacy while she is having her young. this will keep mortality of the young down to a great extent. Be sure there is plenty of dried hay in the pen when she is "due".
- A solid compartment about 1 1/2 feet long and 1 1/2 feet wide should be included in the pen to give the doe privacy while she is having her young. this will keep mortality of the young down to a great extent. Be sure there is plenty of dried hay in the pen when she is "due".
- Know that female rabbits will conceive at any time they have an "encounter" with a buck. There is no set estrous period.
- The young should be separated from the mother at about 6 weeks.
- The doe is ready for breeding immediately after separation from her young.
- The rabbit pregnancy period is 28-30 days, with the doe able to mate within hours of giving birth.
- The young should be separated from the mother at about 6 weeks.
- The pen should be furnished with clean water each day. The water should be contained in such a way that the animal will not contaminate it with its body waste. If in an open container, it should be elevated so that the top is at least 4 inches above the floor. Conventional water bottles work very well also.
- Feed a good quality hay. Be sure it has a sweet smell, and has not been water-damaged and become moldy. Red clover and birdsfoot trefoil seem to be the most preferred by rabbits, but they will also do well on alfalfa, Kentucky bluegrass, timothy, and a mixture of native grasses.
- Hay should be contained in a lattice manger, or rick to keep it from being contaminated by the animal's waste. Do not feed lettuces. Any fresh green food such as lettuce from the store or grass from the yard can give your animals diarrhea!
- Another feeding option can be to use calf manna along with rabbit pellets, or "rabbit food". Medicated calf pellets, available at a feed mill which dairy farmers frequent, can help keep your rabbits free from diarrhea. They will cost you less than the "bunny" pellets per pound, but can contribute to the overuse of antibiotics and are not available in all cities. Very important: When you are ready to butcher, place your animals in an especially clean environment for 2 weeks prior to slaughtering and feed them conventional rabbit pellets rather than the medicated calf food to clear the rabbits from the effects of the anti-biotic which is in the calf food. Remember these rabbits will not be considered organic which is a personal choice.
Enjoying the 'payoff'
- The first is to sell them to a meat processing plant, the second is to slaughter and butcher them for your own use, or to sell the meat after you have processed it.
- To locate a meat processing plant, the best thing to do is go to different grocery stores and ask where they are buying their meat from. Explain that you are thinking of raising rabbits and are researching the market possibilities. Many of them will be happy to help you.
- When you have located several markets who might buy your product, contact them and see if they would be willing to purchase live animals from you. If possible, set up a contract with them to produce whatever you feel you are able to.
- Wisdom tells us that you should have a good sound business plan worked out before you even start to raise a single rabbit.
- To slaughter, attach two stout cords to a bar about 2 feet above your head and about 2 feet apart. The lower end of the cords must have a slip knot on each of them.
- You will need a 12" to 18" length of 1/2 inch pipe to kill the animal. You will also need a keenly sharpened knife to skin and eviscerate the animal. You will need a pan to place the carcass of the animal in after you have skinned and eviscerated it.
- You will need a 12" to 18" length of 1/2 inch pipe to kill the animal. You will also need a keenly sharpened knife to skin and eviscerate the animal. You will need a pan to place the carcass of the animal in after you have skinned and eviscerated it.
- Remove the animal from its cage, seize it by both hind feet with one hand, and insert one of its hind feet, on the toe end of the joint, but just below the first joint, in one of the slip knots, so that the belly will end up facing you.
- Slip the other foot in the remaining slip knot likewise.
- While the animal is hanging, pull its neck out straight, and, seizing the pipe with the other hand, give a quick, sharp hard blow where the neck and skull of the animal meet, being sure you don't hit your own hand. If you have done this right, the animal is for all intents and purposes, dead.
- With your sharp knife, remove the head, being careful to keep the blood from getting on you. Give the carcass a little time to bleed out
- With your sharp knife, remove the front feet.
- Skin the animal according to whether you want to save the pelt or hide. Rabbits are very easy to skin. If you don't want to save the hide, simply cut a slit in the small of the back and pull the lower part down and off.
- Cut the tail off close to the carcass, cut the skin around the feet hocks. Slit the skin from the feet to the belly on each side, Then slit the skin (but not the belly) on down to the end.
- When the skin is off, slit the belly meat from the crotch on up through, and part the ribcage through the breast plate on up to the neck.
- Using your sharp Knife, cut through the front of the pelvic bone, being careful not to cut into the anal canal, which will be filled with feces.
- Remove all the visceral matter from the carcass.
- Save whatever internal organs which you desire, such as the heart, liver and kidneys.
- Cut off each hind foot, leaving it in the slip knot.
- Place carcass in the container and chill immediately. You may save the meat for later cleaning, quartering, butchering, cooling, cooking or freezing.
General Rabbit Information
- Mature bucks should not be kept in the same pen, as one or both will be castrated by the other.
- Rabbits are sensitive to too much heat, and the pen should be shaded and well ventilated in the summer.
- In the winter, the pen should be protected from wind, and most of its screen areas should be covered. Be sure to keep plenty of hay or straw in the pen for bedding.
- Rabbits reach maturity somewhere between 6 and 10 months of age depending on the breed. Smaller breeds mature quicker than larger.
- The following breeds will weigh approximately this much when fully mature; Netherland Dwarf 2 1/2 lbs., Jersey Wooley 3 1/2 lbs., Holland Lop 4 lbs., Mini-Rex 4 1/2 lbs., Dutch 5 1/2 lbs., Havana 5 1/2 lbs., Florida White 6 lbs., Mini Lop 6 1/2 lbs., Rex 9 lbs., Palomino, 10 lbs., Satin 11 lbs., New Zealand 11 lbs., French Lop 12 lbs., Flemish Giant 13+ lbs.
- The following breeds will weigh approximately this much when fully mature; Netherland Dwarf 2 1/2 lbs., Jersey Wooley 3 1/2 lbs., Holland Lop 4 lbs., Mini-Rex 4 1/2 lbs., Dutch 5 1/2 lbs., Havana 5 1/2 lbs., Florida White 6 lbs., Mini Lop 6 1/2 lbs., Rex 9 lbs., Palomino, 10 lbs., Satin 11 lbs., New Zealand 11 lbs., French Lop 12 lbs., Flemish Giant 13+ lbs.
- Pellets should be fed to rabbits in the following portions; Dwarfs 1/2 cup per day, Mini-Lops 3/4 cup per day, Larger rabbits 1 cup per day, Flemish Giant 1 1/2 cups per day.
- Clean each pen at least once per week, throwing out all bedding material, and replace it with new, clean bedding.
Tips
- Rabbits should never be lifted by their ears, as it hurts them and damages their ears!
- To handle a rabbit, grasp a handful of the loose skin over the upper part of its shoulder blades. Rabbits have very sharp toenails on their hind feet, and they can inflict painful scratches on you if you're not careful. To practice lifting a rabbit, use a glove with a long gauntlet on the lifting hand, and a coat or heavy lined shirt. You will soon learn how to lift a rabbit bare armed by observing where to keep your wrist and arm, which will be as close to the animal's body as possible, and with your forearm as close to the center of its spine for its full length as possible.
- Tame rabbits generally will not bite you. It is not their nature to do so. Hares are a different matter.
- Occasionally, rabbits, like any other lagomorph, will develop longer teeth than they need. Longer teeth are caused by lack of enough coarse food to keep their teeth ground down, or from a condition known as malocclusion. Lagomorphs are continually growing their teeth out longer, like we do our fingernails. This can be a problem if they are not properly trimmed. Use a pair of large toenail snippers or a small set of wire cutters to trim extra long teeth and relieve the animal of further distress and make it possible for them to eat properly. This will not hurt the animal like it would you or I, because they are built different in this respect. Their teeth will continue to grow on out again.
Warnings
- Wash your hands before and after slaughtering or butchering to avoid infections.
- Never use rabbit livers for food if they have white spots in them. Use only if they are of a clear, dark color. Be sure to remove the bile sack from the liver.
- Do not slaughter or butcher if you have an open wound or cut, to avoid infections.
Related wikiHows
- How to Raise Rabbits
- How to Pet a Rabbit
- How to Choose Your Pet Rabbit
- How to Give a Rabbit Medication
- How to Handle Rabbits
Article provided by wikiHow, a wiki how-to manual. Please edit this article and find author credits at the original wikiHow article on How to Raise Rabbits for Food. All content on wikiHow can be shared under a Creative Commons license.
